Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove throttle body intake box and save bolts.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”)
7. Locate (3) extension plates (short) and (3) 6mm x 20mm flat head screws before installing throttle linkage and dipstick bracket.
* Please Note: Remove the stud from front throttle linkage mount. The dipstick must be located under forward extension plate at flathead screw location.
8. Locate (2) extension plates (long) using (2) 6mm x 20mm flat head screws to reposition the throttle body intake box using saved bolts. Refer to Step 3.
9. Install air box extension plate using flange nut and 5/16″ flat head screw.
download here
No comments :
Post a Comment
Note: Only a member of this blog may post a comment.