2001-2003 Acura 3.2 CL cold air system installation instructions

Installation for the 2001-2003 Acura 3.2 CL cold air system:
1) Introduction
whether a vehicle is branded) parked on a level surface.
(b)) and set the parking brake.
c) Disconnect the negative battery terminal.
d) if the engine has been started within the last two hours to cool down.

2) removal of stocks of the intake air
delete a set of primary field) air and attach equipment on the inside of the fender well.
(b), disconnect the breather hose) and air hose, fuel-injection Control System air intake Duct.
(c)) and remove the cord pull in air inlet throttle body.
d) Jack on the front of the vehicle and support using the correctly rated stands of Jack.
and) delete lower front splashguard.
II), delete the Left front tire and remove inside splashguard (inner fender liner).
(e)) delete resonator from underneath the vehicle.

3) installing cold air
the long Serpent) install a connector 2 "at the end of the body of the throttle body of the pipe. This is the end nearest the nipple breather.
i will give is to install a clamp) hose, 2.50 "the hose connector and loosely tighten. Install the clamp for hose 2.75 "on the other end of the hose connector. 3.2 CL/TL-Install hose clamp hose connector 2.75 "loosely tighten. Install the clamp for hose 2.75 "on the other end of the hose connector.
b) install the pipe per unit of the throttle.
and support on the card) to the inlet pipe line will be well with the threaded hole on the inner fender. Install rubber Isolator mount and connect air inlet duct mount rubber. The large fender washer and nut for stud-Insulation installation and snug down. Rubber mount installation error causes a loss of all the guarantees of Cold air. Below is a diagram of how mount rubber should be installed.
c) install another hose connector at the other end of the inlet conduit. Lightly tighten the two hose clamps around the hose connector.
d) install the secondary through the inlet pipe, which left exposed after removing the resonator O.E.. Slide the end of the tube to hose connector and gently tighten the clamps-hose.
and on the tab below) support pipe should be aligned with a hole in the bottom inside of the fender well just below protrude. In some vehicles will be a bunch of plastic wire through this hole, if yes please delete it. To install a second mount rubber Isolator for that hole. Using the fender Washer nut is a large and secure the body of vehicles. For stud install Isolator by using other large fender washer and lock nut, you must attach the maintenance tab. Rubber mount installation error causes a loss of all the guarantees of Cold air. Refer to the diagram above mounting installation of Isolator rubber.
e) filter installed at the end of the inlet conduit AEM. Push the filter at approximately 2 cm above the intake pipe and install one hose clamp to secure the filter to the inlet pipe. After checking the niewmontowanych you can either push the filter to the inlet of a more or less, depending on the clearances.

get

Advertisement: