Installation instructions:
Step 1-set QuickLIFT unpack and check the contents. Remove all items from the tube packaging. Should have the following before you begin: * (2) gas Springs – be sure to cycle them several times before installing! * (4) 3/16 "Steel Multi-grip rivets * (2) aluminium rivets 3/16" (longer than the above) is used to stabilize the parentheses. * (4) 5/16 "head blachowkrety sheet * (2) the Fender steel brackets is an angle of 90 degrees * (2) Hood steel brackets is 110 degrees (angle) * printed instructions * gas spring locking clips (springs gas is removed before the Assembly is that they do not LOSE!).
Step 2-collect the required tools. You should collect the following utilities before you begin Setup: * power drill * (3/16 "and indexed # 11) and 5/32"drill bit * socket 5/16 "and socket wrench * Fine indelible marker or felt tip * measure tape or ruler * Hammer and Center punch * Rivet gun, capable of rivets 3/16" (most brands can handle this size).
Step 3-character extension locations on fender bracket (driver's side) and a hood. A. leave its hood closed. Using (2) pieces of tape and a permanent marker, mask the exact measure of corner hood (near the hinges and windshield) along the line of fender. Place the marker on the tape, masking fender for an 8-3/4. Place your second character and the mask masking tape on 23-1/4, as shown in the right. Verify that these measurements!
No comments :
Post a Comment
Note: Only a member of this blog may post a comment.