Installation instructions:
STEP 1:
Connect the 14 pin connector on the of the loom supplied to the network adapter.
STEP 2:
Connect the unilink connector and 3.5 mm jack plug of the supplied loom to the rear of the unit head of Sony. Ensure the arrow is on top of the unilink connector and plug jack 3.5 mm that is pushed firmly on the main unit of Sony.
STEP 3:
Insert the original power and speaker leads with vehicle harness Connects2.
STEP 4:
Unit head of Sony Connect unused at the end of the supplied cables.
STEP 5:
If the Assembly auto-changer unilink bus, connect the cable supplied with the auto-changer unilink slot for the card to. Connect audio leads with auto-changer unit head Sony as normal. (See fitting instructions with autochanger for further information).Download
No comments :
Post a Comment
Note: Only a member of this blog may post a comment.