Place the clutch, clutch disc, diaphragm spring clutch disk, mitsubishi eclipse, surface plates, limit 0, flywheel, curves, looseness, grease, illustration, cracks, mitsubishi, removing the service point: move the release fork in the direction of delete the clip from the fulcrum. Service installation point 1. Application of Mitsubishi part number of the original grease or equivalent illustrated positions the release fork. 2. install the fork entry at the fulcrum.
Clutch disc and clutch cover installation 1. Application of Mitsubishi part number of the original grease 0101011 or equivalent curves drive clutch and rub in splines by using the brush. 2. using the Guide disk clutch to place the drive clutch on the flywheel. 3. Install the lid of the clutch on the flywheel. The outer race: Press installation in grooves wedge to fork entry into position on the illustration. Release fork installation: use Mitsubishi part number of the original grease 0101011 or equivalent illustrated positions the release fork. Sealing CAP: Press installation in sealing the CAP to the position in the illustration. Make sure that it is not installed in the position of the skewed. Clutch inspection: 1. Verify that end-of-spring diaphragm wear and uneven height. Replace If consumption is obvious or height difference exceeds the limit. Limit: 0.5 mm (0.020 inches) 2. Check the surface of the plate pressure for consumption, cracks or discoloration. 3. check the rivets plate strap on looseness.here
No comments :
Post a Comment
Note: Only a member of this blog may post a comment.